Add a simple SpacemiT I2C driver for basic byte transfers over the I2C
bus, prioritizing simplicity over performance. The driver operates in
PIO mode and does not use interrupts, FIFO, or DMA.
The controller is reset at the start of each transaction to ensure a
known initial state, regardless of prior configuration by the kernel.
This also avoids the need for additional error recovery code.
This will be used for communication with onboard PMIC to reset and
power-off the board.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Tested-by: Anand Moon <linux.amoon@gmail.com>
Link: https://lore.kernel.org/r/20260419150857.2705843-2-aurelien@aurel32.net
Signed-off-by: Anup Patel <anup@brainfault.org>
From version 2.38, binutils default to ISA spec version 20191213. This
means that the csr read/write (csrr*/csrw*) instructions and fence.i
instruction has separated from the `I` extension, become two standalone
extensions: Zicsr and Zifencei. As the kernel uses those instruction,
this causes the following build failure:
CC lib/sbi/sbi_tlb.o
<<BUILDDIR>>/lib/sbi/sbi_tlb.c: Assembler messages:
<<BUILDDIR>>/lib/sbi/sbi_tlb.c:190: Error: unrecognized opcode `fence.i'
make: *** [Makefile:431: <<BUILDDIR>>/build/lib/sbi/sbi_tlb.o] Error 1
The fix is to specify those extensions explicitly in -march. However as
older binutils version do not support this, we first need to detect
that.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Reviewed-by: Bin Meng <bmeng.cn@gmail.com>
Tested-by: Alexandre Ghiti <alexandre.ghiti@canonical.com>
Reviewed-by: Anup Patel <anup@brainfault.org>
When the watchdog is running the HiFive Unmatched board does not reboot
properly and shuts down itself a few seconds after reboot, in the early
stages of the u-boot loading. On a Linux kernel this happens when the
da9063_wdt module is loaded. This does not happen if the module is
unloaded before reboot or if the watchdog module is loaded with
"stop_on_reboot=1".
Fix that by stopping the watchdog before attempting to reset the board.
This is done by zeroing the TWDSCALE field of CONTROL_D register, unless
it was already set to 0.
Reported-by: Tianon Gravi <tianon@debian.org>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Reviewed-by: Nikita Shubin <n.shubin@yadro.com>
Tested-by: Nikita Shubin <n.shubin@yadro.com>
Reviewed-by: Anup Patel <anup@brainfault.org>
da9063_reset() and da9063_shutdown() take the chip address in argument
(like similar functions), but in practice use the da9063 global struct
instead. Fix that.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Reviewed-by: Nikita Shubin <n.shubin@yadro.com>
Reviewed-by: Anup Patel <anup@brainfault.org>
Reviewed-by: Xiang W <wxjstz@126.com>
